ADJUSTING COPPER LEVELS ON UNITS INSTALLED PRE OCTOBER 2019:
To adjust the copper level simply go to Calculators within the Naked Pools App, enter the pool size and your current copper level and adjust the ION SET to 100% for the amount of days indicated.
During the BOOST time check levels every few days to ensure levels stay within the recommended range (0.2-0.5ppm). Use the reminder feature to receive a text message once the BOOST has completed and reduce the ION SET back to 20%.
ADJUSTING COPPER LEVELS ON UNITS INSTALLED POST OCTOBER 2019:
See the video below and if in doubt, please CONTACT US and we will assist you.
During the BOOST time check levels every few days to ensure levels stay within the recommended range (0.2-0.5ppm).
NOTE: ION BOOST will only operate for a set period of time each day based on the pool size and resets every 24 hours, so depending on the pool size this may take a number of days. If an external controller is installed and ION BOOST is activated the same rule applies.
Before increasing copper levels please ensure that the pH level was within range at the time the copper test was performed and you have followed the copper test kit instructions carefully.
It is worth noting that when the water temperature is below 20 degrees that you should allow the copper test to stand for at least 10 mins to fully react to ensure an accurate result.
It is also important to ensure that the reagents for the Naked Copper Test Kit are not beyond their expiry date to achieve an accurate result.
The expiry date can be found on the label of the bottle under the batch number as shown below.