Little or no maintenance is normally required with the Naked Freshwater System Control Unit.
- Ensure the Control Unit 3 pin plug is connected into a suitable weatherproof RCD protected 10amp outlet.
- Ensure that the pump plugs into the 3 pin AC Socket located at the bottom of the Control Unit.
- Check all plugs and cords for damage. If damaged then it should be replaced by the manufacturer, their agent or similar qualified person, in order to avoid a hazard.
If the system is to be hard wired, then a qualified electrician must complete the installation.
The Naked Freshwater System Control Unit has air vents to allow internal components to remain cool in hot weather. It has a special oil spray applied to the inside of the unit during production to stop insects from entering the unit. To help assist in keeping the insects away, apply a surface spray periodically on the wall or post that the unit is mounted on.
DO NOT spray directly into the Control Unit and make sure the power is off when you spray. Allow adequate time for the spray to dry before turning power on again.