AUTO/ON/OFF - Lights will show the mode of the system BLUE-AUTO GREEN-ON RED-OFF
FAULT - Shows red if there is a fault but importantly the fault message will display on the screen as to what the issue may be. Refer to your Operating Manual for further details.
POWER/MODE - Pressing will switch unit to OFF, press again to ON (Manual), press again back to AUTO. NOTE: If the unit is left in "ON" mode, when the next Timer is due to start the unit will switch back to "AUTO" automatically.
OXI BOOST - Puts the unit into "ON" mode and runs the Oxidiser for 24 hours or a reduced period by pressing the [-] button. Ideal for heavy bather loads or when the pool has seen adverse weather conditions.
ION BOOST - Models prior to October 2019, pressing ION will show the setting of the Copper/Silver Ioniser. By default this is usually 20% and can be adjusted by pressing either [+] or [-] buttons. Models post October 2019 pressing the button will allow you to automatically boost the amount of copper in the pool.
CLOCK/TIMERS - Used to set the clock, adjust the run times of the pool or to switch between a dual or single timer option.
BACKWASH - This button will step you through the process of backwashing a sand, glass or cartridge filter when the pump is plugged into the Naked system. It will automatically step you through the process and switch the pump on/off as required.
WINTER MODE - This button will automatically reduce your OXI and ION output by 50% depending upon its current setting. Ideal for colder months when water is colder it is not as affected by bacteria and typically you will not be using the pool as much.